DJI Mavic 3 Multispectral

1. Standard weight of the aircraft (including battery, propellers, and microSD card). The actual product weight may vary due to differences in batch materials and external factors. Use for reference only.

2. The max speed in the EU cannot exceed 19 m/s.

3. Max wind resistance during takeoff and landing.

4. Data measured using the DJI Mavic 3M in a wind-free environment while flying at sea level at a constant speed of 36 kph until there was 0% power remaining. For reference only. Please pay attention to Return to Home prompts in the DJI Pilot 2 app when flying.

5. Data measured using the DJI Mavic 3M in a wind-free environment hovering over sea level until there was 0% power remaining. For reference only. Please pay attention to Return to Home prompts in the DJI Pilot 2 app when flying.

6. Data measured using the DJI Mavic 3M in a wind-free environment while flying at sea level at 57.6 kph until there was 0% power remaining. For reference only. Please pay attention to Return to Home prompts in the DJI Pilot 2 app when flying.

7. In some countries, the 5.1/5.8 GHz frequencies are prohibited, or the 5.1 GHz frequency is only allowed for indoor use. Please refer to local laws and regulations before use.

8. Data measured flying in an unobstructed outdoor environment free of interference. It shows the farthest communication range for one-way, non-Return to Home flights under each standard. Please pay attention to Return to Home prompts in the DJI Pilot 2 app when flying.

9. Data measured in an unobstructed environment with typical interference under various standards. The actual flight distance may vary and is for reference only.

10. The DJI RC Pro will support more DJI aircraft in the future.

Avoid blocking the sunlight sensor during operation. If the sensor is obstructed, vegetation indices like NDVI cannot be accurately obtained. Additionally, do not rub or scratch the surface of the sensor, as this may affect its performance.

No, the DJI Mavic 3M is not waterproof. Avoid flying in rain, snow, or high-humidity environments.

You can access network RTK services by connecting the remote controller to Wi-Fi. A 4G SIM card is not required.

The network RTK service is bound to the remote controller, not the aircraft.

DJI Mavic 3M has a total of five cameras: four single-band multispectral cameras (5.5 MP each) and one RGB camera (20 MP).
The wavelengths for the multispectral cameras are:

• Green (G): 550 nm ± 16 nm

• Red (R): 650 nm ± 16 nm

• Red Edge (RE): 730 nm ± 16 nm

• Near-infrared (NIR): 860 nm ± 26 nm

Most crop and vegetation monitoring is based on near-infrared, red edge, red, and green bands. Common vegetation indices like NDVI, NDRE, and GNDVI use only two or three of these four bands. Therefore, the lack of a blue band has little to no impact on major agricultural and environmental monitoring tasks.

• Multispectral camera: 4.34 mm focal length (equivalent to 25 mm in 35mm format)

• RGB visible camera: 12.29 mm focal length (equivalent to 24 mm in 35mm format)

The image captured is a DN (Digital Number) value, not a reflectance value.

Yes. Each camera’s sensor center is compensated in the EXIF metadata based on its position relative to the onboard D-RTK antenna’s phase center. When you create a map in DJI Terra or DJI SmartFarm Platform, this position compensation is applied automatically to ensure mapping accuracy.

Yes. Both the RGB and multispectral cameras are individually distortion-corrected before shipping.

No, the original image does not come with vignetting correction. However, each photo includes the necessary parameters to perform vignetting correction during post-processing.

Yes. All five cameras are time-synchronized to ensure consistent data for mapping and analysis.

Photos are saved to the microSD card.

• For normal photos: SD card > DCIM > DJI_2022********_***

• For task/mission photos: SD card > DCIM > DJI_2022********_***_task name

For beginners:

• Set the exposure mode for both multispectral and RGB cameras to Auto

• Unlock AE (Auto Exposure)

• The system’s multispectral metering mode is global light metering by default

• Set the RGB camera focus mode to First Waypoint Focus

It captures how objects reflect light across different wavelengths (bands). This data is used in precision agriculture and forestry to monitor crop health, vegetation coverage, and even water pollution. It helps in assessing growth stages, stress levels, and more using indices like NDVI and NDRE.

• FCC: Up to 15 km

• CE/SRRC/MIC: Up to 8 km
  Note: These distances are measured in unobstructed, interference-free outdoor environments. They reflect one-way, non-RTH (Return to Home) transmission ranges. Always monitor RTH prompts in the DJI Pilot 2 App during flight.

The DJI RC Pro Enterprise Edition has 64GB of internal ROM. It also supports microSD cards for additional storage.

Yes, the DJI Mavic 3M is compatible with the MSDK.

No, the cellular module does not include a SIM card. Users must purchase and activate their own SIM cards using their real name, as per local regulations.

No, the cellular module does not support 5G. It supports 4G LTE only.

Only Nano SIM cards are supported. eSIM cards are not compatible.

No, it is not compatible with any of those models.

The DJI Mavic 3 Series remote controller is not compatible with the Mavic 3M.
However, the DJI Mavic 3 Enterprise Series remote controller is compatible with the Mavic 3M.

The battery has a capacity of 5,000 mAh, a voltage of 15.4 V, and an energy rating of 77 Wh.

• Using the DJI 100W USB-C Power Adapter with the DJI Mavic 3M 100W Charging Hub: About 1 hour and 10 minutes

• When charging the battery directly through the aircraft with the same adapter: About 1 hour and 20 minutes

Up to 43 minutes under ideal conditions.
Tested at sea level, windless conditions, and a constant speed of 36 kph until battery depletion (0%). Always monitor RTH (Return to Home) prompts in the DJI Pilot 2 app during flight.

Yes, fast charging protocols PD, QC, and PPS are supported.

Yes, they are compatible with both DJI Mavic 3 Series and DJI Mavic 3 Enterprise Series aircraft.

Use the C1 port on the DJI 100W USB-C Power Adapter for best charging performance.

Yes, the DJI Pilot 2 app supports importing polygon boundaries and waypoint missions using KML/KMZ files for pre-planned aerial photography.
Import Path: Route > KMZ Import > Select Table of Contents > Internal Storage/SD Card > Locate the KML/KMZ file.

Yes, the DJI Pilot 2 app allows DSM file imports for terrain-follow missions during aerial surveys.
Import Path: Flight Path > Create Flight Path > Mapping Mission > Terrain Follow > DSM File Selection > Select Table of Contents > Internal Storage/SD Card > Locate the DSM file.

Yes, flight paths can be scheduled either by importing KMZ/KML files or by creating them directly in the Pilot 2 app.

Yes, vegetation indices such as NDVI can be displayed in real-time during flight via the remote controller.

No, it does not support dual control.

No, it does not support multi-aircraft control.

Not at the moment.

No, these flight modes are not supported.

• Maximum Flight Altitude: 500 meters

• Flight Speed Range: 1 m/s (minimum) to 21 m/s (maximum), measured in no-wind conditions near sea level.

• Visible Camera (Orthophoto): H / 37.2 = GSD in cm/pixel

• Multispectral Camera (Orthophoto): H / 21.7 = GSD in cm/pixel

It’s best to capture data under clear lighting, ideally when the sun’s altitude angle is above 30°.

Yes, it can perform terrain-following either using its downward vision sensors or by importing DSM data.

Yes, it supports AI Spot-Check to automate repetitive inspection tasks. The onboard AI identifies and locks onto subjects of interest to ensure consistent framing in future missions.

The Intelligent Flight Battery and the Propeller Guard are compatible with both models.

No, the DJI Mavic 3M does not support DJI Goggles.

Yes, the Mavic 3M supports the D-RTK 2 Mobile Station for enhanced accuracy.

Yes, the RTK Module comes included with the DJI Mavic 3M.

The PSDK port supports the RTK Module and the official DJI Mavic 3 Enterprise Series Speaker.

No, the charging hub is not included by default and must be purchased separately.

No, the speaker is optional and must be purchased separately.

The adapter includes a USB-C power cable that supports up to 100W output. It charges the DJI RC Pro Enterprise Edition at 30W, the aircraft at 88W, and the charging hub at 100W.

Yes. The Mavic 3M’s Intelligent Flight Battery, DJI 100W USB-C Power Adapter, and DJI Mavic 3 Charging Hub (100W) support PD and PPS protocols. The DJI RC Pro Enterprise Edition supports PD and QC protocols.